16N Installation Guide, V4.2.X (AA-RVULB-TE, April 2004)

Installing the SAN Switch

43SAN Switch 2/8V, 2/16V and 2/16N Installation Guide

a. Assemble the two inner rails (one on each side) to the switch using the

appropriate number (from step 5 on page 42) of #8-32 x 5/16-inch

Phillips pan-head SEMS screws as shown in Figure 10.

Note: The rail kit provides fourteen #8-32 x 5/16-inch screws for assembling the inner

rails. Each switch requires a different number of these screws. For example, Figure 10

shows the an inner rail being attached to the SAN Switch 2/16V with five screws.

Attaching both inner rails requires ten screws.

Figure 10: Assembling the inner rails

Note: For factory integration only, tighten the #8-32 x 5/16-inch Phillips pan-head

SEMS screws

and torque between 6 to 8 inch-pounds.

0012a