HP StorageWorks SAN Switch 2/8V, 2/16V and 2/16N Installation Guide, V4.2.X (AA-RVULB-TE, April 2004)

Installing the SAN Switch
49SAN Switch 2/8V, 2/16V and 2/16N Installation Guide
Create a Serial Connection
Before you can begin configuring the switch, you must create a connection via the
serial port. To create a serial connection:
1. Insert the provided serial cable into the serial port on the switch.
2. Connect the serial cable to an RS-232 serial port on the workstation
(Figure 14).
Figure 14: Connecting the serial cable
If the serial port on the workstation uses an RJ-45 connector instead of an
RS-232, remove the adapter on the end of the serial cable and insert the
exposed RJ-45 connector into the RJ-45 serial port on the workstation.
3. Disable any serial communication programs running on the workstation.
0014a
IOIOI
IOIOI
1
0
0
-
2
4
0
100-240
VAC
1
.0
A
4
7
-
6
3
H
z
C 1.0A 47-63Hz
1
0
0
-
2
4
0
100-240
VAC
1
.0
A
4
7
-
6
3
H
z
C 1.0A 47-63Hz
!