Brocade Fabric Manager Administrator's Guide (53-10000196-01-HP, November 2006)

Fabric Manager Administrator’s Guide 14-23
Publication Number: 53-1000196-01-HP
Rebooting Switches
14
To assign switches to an existing reboot group
1. Click Tasks > Reboot > Create Reboot Sequence.
The Create or Change Reboot Groups and Sequence window displays (see Figure 14-11 on
page 14-20).
2. Select a fabric from the Select Fabric drop-down list.
The switches in that fabric display in the Unassigned Switches list.
3. Select the reboot group that you want to populate.
4. Select a switch that you want to add to the reboot group and click the left arrow.
Use Shift-click and Ctrl-click to select multiple switches; then click the left arrow.
5. Click OK to save the changes and close the window, or click Apply to save the changes without
closing the window.
Performing a Sequenced Reboot
Use the following procedure to create a list of switches to be rebooted and the order in which they are to
be rebooted.
To set up and run a sequenced reboot
1. Log in to the switches that you want to reboot. See “Logging In to Multiple Switches
Simultaneously” on page 4-4 for additional information.
2. Click Tasks > Reboot > Sequence Reboot.
The Sequence Reboot window displays, as shown in Figure 14-14.
Figure 14-14 Sequenced Reboot