Brocade Fabric Manager Administrator's Guide (53-10000196-01-HP, November 2006)

Fabric Manager Administrator’s Guide 17-15
Publication Number: 53-1000196-01-HP
Using the Policy Editor
17
To make changes to the Serial or Front Panel policy
1. In the Information Panel, right-click the secure fabric for which you want to set policies and choose
Security > Security Policy Editor from the context menu.
The Policy Editor appears (see Figure 17-3 on page 17-4).
2. Click the tab that corresponds to the policy you want (Serial or Front Panel).
The selected policy appears (see Figure 17-9 on page 17-14). The Serial policy is used in this
example; the Front Panel policy is similar.
3. Perform either of the following:
To add a switch to the policy, click the switch in the Available Access Points list and then click
Add Switch.
To remove a host from the policy, click the host in the Permitted Access Points field and then
click Remove Switch.
4. Click the Summary tab.
5. Click Save to save your changes but not apply them, or click Activate to save and apply your
changes.
The Security Policy Review dialog displays.
6. After reviewing the Security Policy, click one of the following:
Continue (to continue applying your changes)
Cancel (to cancel your changes)
Copy to File (to copy the Security Policy to a file)
Changing the Admin Security Password
Use the following procedure to change the admin password for secure FCS and secure non-FCS
switches.
To change the password that implements security
1. In the Information Panel, right-click the secure fabric for which you want to change passwords and
choose Security > Security Policy Editor from the context menu.
The Policy Editor appears (see Figure 17-3 on page 17-4).
2. Click the Password tab (see Figure 17-10 on page 17-16).