Brocade Fabric Manager Administrator's Guide (53-10000196-01-HP, November 2006)

18-4 Fabric Manager Administrator’s Guide
Publication Number: 53-1000196-01-HP
Editing a Stored Port Connectivity Configuration
18
• Modify port names
- To add or change the port name, click the Port Name field and type the name.
- To clear all of the port names, click the Clear All Port Names checkbox.
• Analyze zone conflicts
Click Analyze Zone Conflicts to see if there are any problems between the PDCM and the
currently enabled zone configuration. Any port connections that cannot communicate with
each other due to a zone conflict are displayed with a red background. For example, if in the
PDCM port n1 can talk to port n2 even though the ports are not in the same zone, a zone
conflict exists and the background cells are shaded red. The Analyze Zone Conflicts tool
analyzes only zones created by port zoning against the switch port zoning (not WWN).
• Activate the current configuration
a. Click Activate to activate the configuration that is currently displayed.
A confirmation dialog displays.
b. Check the Active=Saved Mode checkbox if you want to save the FICON CUP port
connectivity configuration as an IPL file, in addition to activating the configuration. The
next time the switch reboots, it loads the configuration from this IPL file.
c. Click Ye s to activate the displayed configuration.
Click No to close the dialog without activating the configuration.
• Click Refresh to receive up-to-date information
• Click Save As to save the configuration as a file.
The configuration name must consist of only upper-case letters, digits, hyphen, and
underscore. If you use lower-case letters, they are converted to upper-case.
• Click Cancel to close the dialog.
Editing a Stored Port Connectivity Configuration
This section describes how to view and edit stored port connectivity configurations. It also describes
how to activate a stored port connectivity configuration.