Brocade Web Tools Administrator's Guide (53-0000194-01, November 2006)

7-10 Web Tools Administrator’s Guide
Publication Number: 53-0000194-01
7
Figure 7-3 GigE Port Configuration Wizard: Selecting Tunnels
To configure the FCIP interfaces, routes, and tunnels
1. Click a port in the Switch View to launch the Port Admin module in a separate window (see Figure
5-1 on page 5-2).
2. Click the GigE Ports tab.
3. Select the port you want to configure in the tree on the left side of the window.
4. Click the General subtab.
5. Click Edit Configuration in the task bar.
The GigE Port Configuration wizard launches. The wizard fields are populated with the current
configuration values.
6. Follow the steps outlined in the wizard.
The wizard guides you through the process of creating an IP interface, an IP route, and the FCIP
tunnel.
7. After the wizard completes, verify the setup.
a. Click the IP Interfaces subtab to verify the IP interfaces.
b. Click the IP Routes subtab to verify the IP routes.
c. Click the FCIP Tunnels subtab to verify the FCIP tunnels.
If there is something missing from the setup, see “Managing the FCIP Tunneling Service” on
page 7-11 for adding or editing any of the components.
8. Repeat the above steps on the remote switch.
9. Enable the ports on both ends of the tunnel to use the link.