Brocade Web Tools Administrator's Guide (53-0000194-01, November 2006)

Web Tools Administrator’s Guide 3-9
Publication Number: 53-0000194-01
3
Performing a Fast Boot
A fast boot reduces boot time significantly by bypassing power-on self test (POST).
To perform a switch fast boot
1. Launch the Switch Admin module as described on page 3-3.
2. Click the Firmware Download tab (see Figure 4-2 on page 4-5).
3. Click the Fastboot radio button.
4. Click Apply.
Performing a Reboot
Use the following procedure to reboot the CP and execute the normal power-on booting sequence.
To perform a switch reboot
1. Launch the Switch Admin module as described on page 3-3.
2. Click the Firmware Download tab (see Figure 4-2 on page 4-5).
3. Click the Reboot radio button.
4. Click Apply.
Changing System Configuration Parameters
When you change system configuration parameters for a SilkWorm 24000 configured with two logical
switches, it is on a logical-switch basis. This means that for each logical switch, you must change the
system configuration parameters individually.
You must disable the switch before you can configure fabric parameters.
You can change the following system configuration parameters:
• Switch fabric settings
• Virtual channel settings
• Arbitrated loop parameters
• System services