HP StorageWorks SAN Switch 2/32 V4.2.X Installation Guide (AA-RTQVD-TE, May 2004)

Installing the SAN Switch 2/32
35SAN Switch 2/32 Version 4.2.x Installation Guide
Note: For factory integration only, tighten the #8-32 x 3/16-inch Phillips pan-head
screw with thread lock and torque between 6 to 8 inch-pounds.
Note: The plenum is a required part of this installation when the SAN switch 2/32 is
installed in an HP 9000 or 10000 series, System/e or comparable EIA cabinet.The
plenum allows air to dissipate at the rear of the rack, preventing overheating.
Figure 10: Assembling the inner rails on a SAN Switch with plenum
The components in Figure 10 include:
6. Insert the switch with the attached inner rails into the outer rails.
1
Plenum
2
Switch
0013a
2
1