HP StorageWorks SAN Switch 2/32 V4.2.X Installation Guide (AA-RTQVD-TE, May 2004)

Installing the SAN Switch 2/32
38 SAN Switch 2/32 Version 4.2.x Installation Guide
Connecting AC Power
Follow these steps to power on the SAN Switch 2/32.
Caution: Do not plug the power cords into the power source until the switch is
completely installed in the rack.
1. Connect the SAN Switch 2/32 power cords to the power connectors on the
switch as shown in Figure 13.
Figure 13: Connecting the power cords
2. Attach the remaining ends of the power cords to power outlets.
3. Turn on the power switch (the 1 position indicates power on, the O position
indicates power off). The switch automatically runs POST.
WARNING: Do not connect the switch to the network until the IP address is
correctly set. For instructions on setting the IP address, see “Configuring SAN
Switch 2/32 Network Addressing” on page 39.
SHR-2571A