HP StorageWorks SAN Switch 2/32 V4.2.X Installation Guide (AA-RTQVD-TE, May 2004)

Installing the SAN Switch 2/32
46 SAN Switch 2/32 Version 4.2.x Installation Guide
Note: Configure each port to match the topology of each host or target before
connecting to the device. The default port configuration is fabric, not private loop. The
switch does not auto-sense topology.
Connecting the SAN Switch 2/32 to the Fabric
Execute the following procedure to connect the SFPs and cables to SAN Switch
2/32 ports as required.
Note: The ports and cables used in trunking groups must meet specific requirements.
For a list of these requirements, refer to the
HP StorageWorks Fabric OS 4.2.x Features
Guide
.
1. Remove the shipping plug from the appropriate ports.
2. Position the SFP so that the key (the tab near the cable-end of the SFP) is on
top.
3. Insert the SFP into the port until it is firmly seated and the latching
mechanism clicks.
Note: The SFP is keyed so that it can be inserted only with the correct orientation into
the port. If the SFP does not slide in easily, check the orientation.