HP StorageWorks SAN Switch 2/32 V4.2.X Installation Guide (AA-RTQVD-TE, May 2004)

Installing the SAN Switch 2/32
49SAN Switch 2/32 Version 4.2.x Installation Guide
Recommendations for Cable Management
HP recommends following these cable management guidelines:
■ Plan cable management before installing the switch in a rack.
■ Leave at least one meter of slack for each port cable (this provides room to
remove and replace the switch).
■ If you are using ISL Trunking:
— Group cables by trunking groups.
— The cables used in trunking groups must meet specific requirements. For
a list of these requirements, refer to the HP StorageWorks Fabric OS
4.2.x Features User Guide.
■ Label the fiber optic cables and record the devices to which they are
connected.
■ Keep LEDs visible by routing port cables and other cables directly
downwards or otherwise away from the LEDs.
■ Do not use tie wraps on fiber optic cables; they are easily overtightened and
can damage the optic fibers.
Note: The minimum bend radius for a 50-micron cable is 2 inches under full tensile
load, and 1.2 inches with no tensile load.