San Switch 2/32 v4.1.x - Installation Guide

Updating the Core Switch PID Format
110 SAN Switch 2/32 Version 4.1.x Installation Guide
10. Issue the configenable, (effective_zone_configuration) command.
For example:
configenable my_config
11. Issue the switchEnable command. Enable the core switches first, then the
edge switches.
12. Rebuild the device entries for the affected fabric using the cfgmgr
command.
For example:
cfgmgr -v
This command may take several minutes to complete.
13. If you are not using multi-pathing software, varyon the disk volume groups.
The proper usage would be varyonvg <volume_group_name>. For example:
varyonvg datavg
14. If you are not using multi-pathing software, mount all devices again and
restart I/O. For example,
mount /mnt/jbod
15. If you are using multi-pathing software, re-enable the affected path.
16. Repeat for all fabrics.