San Switch 2/32 v4.1.x - Installation Guide

Installing the SAN Switch 2/32

26 SAN Switch 2/32 Version 4.1.x Installation Guide

Locating SAN Switch 2/32 Serial Numbers

Before contacting HP for technical support or service, obtain the three serial

numbers located on the switch. Each serial number provides specific logistical

information, identifying the device’s manufacturing location.

Table 3: Shipping Carton Contents

Number Item

One HP StorageWorks SAN Switch 2/32 product accessories box

containing:

■ One RS-232 Serial cable (convertible to an RJ-45 connector, by

removing the adapter on the end of the cable)

■ Rack Mount hardware pouch:

—Power cord clips (6)

—3-hole bar nuts (4)

— 10-32 x 3/8 Black Phillips head screws (12)

— 8-32 x 3/16 Phillips head screws (10)

— Square alignment washers (8)

— Right and left rear rack mount brackets (2); use if installing

so that port side slides from the rear of the rack

— Right and left front mount brackets (2); use if installing so

that power supply end slides out from the front of the rack

■ Documentation, release notes, license, warranty, and CD

■ Two country-specific AC power cords

■ Two Power Distribution Unit (PDU) power cords (not shown in

Figure 3)

■ Four rubber mounting feet for stand-alone installations on a

table or lab bench

2 Slide assembly; includes one inner and one outer slide rail, with the

following items preinstalled:

■ L-bracket, slide mount, 3-hole (4)

■ Nut, Hex, Locking, 8-32 (4 nuts in each slide assembly, for a

total of 8)

■ 8-32 x 3/8 inch, zinc slotted screw (requiring a torque of 15

inch-pounds) (8)

3 HP StorageWorks SAN Switch 2/32