San Switch 2/32 v4.1.x - Installation Guide

Installing the SAN Switch 2/32
29SAN Switch 2/32 Version 4.1.x Installation Guide
Power Requirements
Two AC power cords connect to the switch on either side of the rear panel. The
AC power source must meet these requirements:
■ Primary AC Input 100–240 VAC (switch auto-senses input voltage) 47–63
Hz
■ Correctly wired primary outlet, with circuit protected by a circuit breaker and
grounded in accordance with local electrical codes
■ Adequate supply circuit, line fusing, and wire size, as specified by the
electrical rating on the switch nameplate
■ Voltage capability of 85–264 VAC
■ Input voltage frequency of 47–63 Hz
■ Power capability of 75 W maximum
The switch has a universal power supply capable of functioning worldwide
without voltage jumpers or switches. The power supply is auto ranging in terms of
accommodating input voltages and line frequencies.