San Switch 2/32 v4.1.x - Installation Guide

Installing the SAN Switch 2/32
32 SAN Switch 2/32 Version 4.1.x Installation Guide
Installing the Slide Rail Assemblies to the Switch
The SAN Switch 2/32 Rack Mount Kit consists of two slide rail assemblies
consisting of an inner slide rail attached to an outer slide rail. Read the following
sections for complete instructions on first separating, then installing the Slide Rail
Assemblies.
Separating the Inner Slide Rail Assembly from the
Outer Slide Rail Assembly
Separate the two inner (smaller) slide rails from the two outer (larger) slide rails as
follows.
1. Holding one slide rail assembly horizontally, pull the inner slide rails out of
the outer slide rail until the lock release lever engages.
2. Press the lock release lever located on the inner slide rails. The inner slide rail
separates from the outer slide rail.
3. Repeat steps 1 and 2 to separate the second slide rail assembly.
4. Put the outer slide rails aside. Follow the steps in the next section, “Attaching
the Inner Slide Rails to the Switch.”
Attaching the Inner Slide Rails to the Switch
Use the following steps to secure each inner slide rail to the switch chassis.
Caution: It is important to install the inner slide rails using the Phillips head,
8-32 x 3/16 screws supplied in the Rack Mount Kit. Installing screws longer
than 3/16 can damage the switch.
1. Position the inner slide rails with the flat side against the switch, oriented in
one of the following two ways: