San Switch 2/32 v4.1.x - Installation Guide

Installing the SAN Switch 2/32
41SAN Switch 2/32 Version 4.1.x Installation Guide
Installing the Switch in the Optional HP System/e Rack
This section provides instructions for installing the SAN Switch 2/32 in the
optional HP System/e rack. The HP System/e Rack Kit consists of the following
items:
■ HP System/e Rack Rail Kit - pre-merger HP part number A7340-87901;
pre-merger Compaq part number QA-71AAA-GZ
■ HP System/e Rack Rail Kit Hardware - part number A7340-87902
The following hardware is required to install the HP System/e Rack Mount Kit:
■ Rails rear mounting brackets
■ Rail mounting hardware, shown next
:
Caution: For proper airflow, the SFP media side of the SAN Switch 2/32
faces the rear of the rack. This mounting allows air to enter from the front of
the rack and to exhaust at the rear of the rack, similar to other rack-mounted
equipment. This prevents switch overheating, which may cause it to fail.
(6) #8-32 x 5/16 Phillips pan-head screw with captive star lock
washer
(6) #8 Flat washer
(6) M5 Torx head screw with captive lock washer
(2) Rubber washer
(4) M5 U-type Tinnerman clip