San Switch 2/32 v4.1.x - Installation Guide

Installing the SAN Switch 2/32
42 SAN Switch 2/32 Version 4.1.x Installation Guide
Use these steps to install the switch in the HP System/e rack.
1. Verify that all required hardware is available.
2. Choose a mounting location in the rack for the switch.
3. Install each of the two mounting brackets with (1) M5 Torx head screw with
captive lock washers as shown in Figure 8.
Figure 8: Installing the mounting brackets
4. Install (2) M5 U-type Tinnerman clips for each of the front columns of the
rack in the top and bottom positions of the three-hole EIA pattern as shown in
Figure 9.
SHR-2581A