San Switch 2/32 v4.1.x - Installation Guide

Installing the SAN Switch 2/32
43SAN Switch 2/32 Version 4.1.x Installation Guide
Figure 9: Installing the Tinnerman clips
5. Assemble the outer rails by completing the following steps:
a. As an aid in assembly, two rubber washers have been included to help
keep the rear slotted portion of the outer rail flush against the rear rail-tray
brackets. Install them as shown in Figure 10.
b. Insert the alignment pins attached to the outer rail front flange into the
center opening in the rack.
SHR-2582A