San Switch 2/32 v4.1.x - Installation Guide

Installing the SAN Switch 2/32
59SAN Switch 2/32 Version 4.1.x Installation Guide
Setting Network Addresses via a Serial Connection
Use the following steps to verify or change the SAN Switch 2/32 IP address,
subnetmask, or gateway address.
Note: During first time setup, you must replace the factory IP, subnetmask, and
gateway addresses with addresses provided by your Network Administrator.
1. Remove the shipping plug from the SAN Switch 2/32 Serial port.
2. Connect the Serial cable to the SAN Switch 2/32 Serial port; see Figure 20.
Figure 20: Connecting the Serial cable
3. Connect the other end of the Serial cable to an RS-232 Serial port on the
workstation. If no RS-232 Serial port is available on the workstation, the
adapter on the end of the Serial cable can be removed to use the RJ-45
connector to create a Serial connection.
4. Verify that the switch power is on and POST is completed. See the “Power On
Self-Test” section, earlier in this chapter.
5. Power on the workstation and establish a connection to the switch using a
terminal emulator application (such as HyperTerminal).
SHR-2572A