San Switch 2/32 v4.1.x - Installation Guide

Installing the SAN Switch 2/32
60 SAN Switch 2/32 Version 4.1.x Installation Guide
Note: These steps show instructions specific to HyperTerminal. If using a different
application, consult the specific application’s documentation.
6. Using HyperTerminal (or similar application), configure the port settings as
follows:
■ Bits per second: 9600
■ Databits: 8
■ Parity: None
■ Stop bits: 1
■ Flow control: None
To configure port settings in a UNIX
®
environment, type:
tip /dev/ttyb -9600
7. Login to the switch (with administrative privileges). The default
administrative logon is admin and the default password is password.
a. Enter the following at the prompt:
ipAddrSet
b. Enter the following information at the corresponding prompts, as in the
example below:
Example
c. To verify that the IP address was entered correctly, type:
ipAddrShow
switch:admin> ipaddrset
Ethernet IP Address [10.77.77.77]:10.32.53.47
Ethernet Subnetmask [255.0.0.0]:255.255.240.0
Fibre Channel IP Address [0.0.0.0]:
Fibre Channel Subnetmask [0.0.0.0]:
Gateway IP Address [0.0.0.0]:10.32.48.1
Set IP address now? [y = set now,n=next
reboot]:y
IP address being changed...
Committing configuration...Done.
switch:admin>