San Switch 2/32 v4.1.x - Installation Guide

Managing the SAN Switch 2/32
75SAN Switch 2/32 Version 4.1.x Installation Guide
LEDs on the Non-Port Side of the SAN Switch 2/32
The non-port side of the switch contains the following LEDs, see Figure 24:
■ One Port Readiness LED on right side
■ One Power Supply LED next to the AC power switch on each power supply
■ One Fan Failure LED at the top of each fan assembly (inside the bezel)
Figure 24: LEDs on non-port side of SAN Switch 2/32
Table 5 describes the LEDs on the non-port side of the switch.
Port Status
LED
(continued)
Alternating
green and
orange
Port is bypassed. Reset the port from
a management
station or check
configuration of
the Fibre Channel
loop.
Port Speed
LED
Above
each port,
on right
No light The port is
transmitting/
receiving at 1
Gbps.
No action
required.
Steady
green
The port is
transmitting/
receiving at 2
Gbps.
No action
required.
Table 4: Front Panel LED Patterns During Normal Operation (Continued)
LED Name
and
Location
LED
Location
Color
Display
Hardware
Status
Recommended
Action
1 Power supply LED
2 Fan failure LED
3 Port readiness LED
SHR-2579A
1
32