San Switch 2/32 v4.1.x - Installation Guide

Managing the SAN Switch 2/32
81SAN Switch 2/32 Version 4.1.x Installation Guide
2. At the command line, enter the following command:
Password admin
An interactive session is opened and you are prompted for configuration
values.
3. At the New username prompt, enter a new name for the admin user. You
can change the name of the admin user without changing the password. Press
Enter to leave the name as is.
4. At the Old Password prompt, enter the old password.
5. At the New password prompt, enter the new password. The new password
must be from 8 to 40 characters in length.
6. At the New password prompt, enter the new password exactly as entered to
the previous prompt.
7. Press Enter to commit the configuration to the firmware.
Note: Save your passwords in a safe place. It is nearly impossible to access a switch
without knowing the switch password.
Configuring the IP and Fibre Channel Address
The SAN Switch 2/32 is shipped with a default IP address of 10.77.77.77.
Use these steps to change the default IP Address and configure the Fibre Channel
IP address of the switch.
1. Login to the switch as the admin user.
2. At the command line enter the following command:
ipAddrSet
An interactive session is opened and you are prompted for configuration
values. Press Enter to skip a prompt and leave the parameter value as is.
3. At the Ethernet IP Address prompt, enter the new IP address for the
Ethernet port on the switch. Press Enter.
4. At the Ethernet Subnetmask prompt, enter the address of the
subnetmask, if applicable. Press Enter.
5. At the Fibre Channel IP address prompt, enter the Fibre Channel
IP address for the switch. Press Enter.