San Switch 2/32 v4.1.x - Installation Guide

Managing the SAN Switch 2/32
82 SAN Switch 2/32 Version 4.1.x Installation Guide
6. At the Fibre Channel Subnetmask prompt, enter the address of the
subnetmask, if applicable. Press Enter.
7. At the Gateway Address prompt, enter the IP address of the gateway
system if applicable. Press Enter.
The configuration is then committed to the switch firmware.
8. You are prompted either to make the IP address changes active now or at the
next reboot. Enter y at the prompt to have the IP address changes take effect
immediately.
Displaying Devices within the Fabric
To verify that you have fabric-wide connectivity when you install a new switch,
display the fabric-wide device count from the newly installed switch. Use these
steps to display the fabric.
1. Login to the switch as the admin user.
2. At the command line, enter the following command:
nsAllShow
This command displays all the connected devices in the fabric.
Checking the Firmware Version
Use these steps to display the SAN Switch 2/32 firmware version.
1. Login to the switch as the admin user.
2. At the command line, enter the following command:
version
This command displays the Kernel version and Fabric OS release number.