San Switch 2/32 v4.1.x - Installation Guide

Managing the SAN Switch 2/32
83SAN Switch 2/32 Version 4.1.x Installation Guide
Setting the Switch Date and Time
All switches maintain current date and time in non-volatile memory. Date and
time are used for logging events. Switch operation does not depend on the date
and time; a switch with an incorrect date and time value still functions properly.
Uses these steps to set the date and time of a switch.
1. Login to the switch as the admin user.
2. At the command line, enter the following command:
date "MMDDhhmmYY"
where:
— MM is the month, valid values are 01–12.
— DD is the date, valid values are 01–31.
— hh is the hour, valid values are 00–23.
— mm is minutes, valid values are 00–59.
— YY is the year, valid values are 00–99.
Note: Year values greater than 69 are interpreted as 1970–1999; year values less
than 70 are interpreted as 2000
–2069. The date function does not support daylight
saving time or time zones.
Displaying Switch Configuration Settings
Use these steps to display the system configuration settings.
1. Login to the switch as the admin user.
2. At the command line enter the following command:
configShow
The system configuration settings display.