San Switch 2/32 v4.1.x - Installation Guide

Managing the SAN Switch 2/32
86 SAN Switch 2/32 Version 4.1.x Installation Guide
The Fabric OS identifies the power supplies as follows (viewing the switch from
the non-port side):
■ Power supply #1 is on the right when viewing the switch from the non-port
side.
■ Power supply #2 is on the left when viewing the switch from the non-port
side.
To determine whether a power supply requires replacing:
■ Check the Power Supply LED next to the AC switch
■ Enter the psshow command
■ In Web Tools, click the Power Status icon
Fan Assemblies
The three fan assemblies are hot-swappable if replaced one at a time. The fan
assemblies are identical and fit into any fan assembly slot; see Figure 26.
Figure 26: Power supplies and fan assemblies locations
Each fan assembly contains two fans, identified by Fabric OS as follows (viewing
the switch from the non-port side assembly on the right contains fans #1 and #2).
■ The fan assembly in the center contains fans #3 and #4.
■ The fan assembly on the left contains fans #5 and #6.
1 Power supply #2
2 Fan assembly containing fans 5,6
3 Fan assembly containing fans 3,4
4 Fan assembly containing fans 1,2
5 Power supply #1
SHR-2580A
1 3 4 5
2