San Switch 2/32 v4.1.x - Installation Guide

Backing Up the Configuration and Upgrading Firmware
90 SAN Switch 2/32 Version 4.1.x Installation Guide
Backing Up System Configuration Settings
HP strongly recommends saving the configuration after the initial configuration
changes and periodically thereafter.
FTP must be used on Windows workstations to back up the system configuration.
The FTP server must be running before an upload can occur. Use the RSHD
service or FTP on a UNIX machine.
Note: The two supplied utilities, RSHD.EXE and CAT.EXE currently do not support
uploads for Windows, only downloads. These utilities are available from the support
web site:
http://www.hp.com/support/
Use these steps to upload a backup copy of the configuration settings to a host
computer.
1. Verify that the RSHD service (on a UNIX machine) or the FTP service (on a
Windows or UNIX machine) is running on the host workstation.
2. Login to the switch as the admin user.
3. At the command line enter the following command:
configUpload hostIPaddr, user, path_filename,password
For example, hostIPaddr is the IP address of the host computer, user is the User
ID used to log into this computer, path_filename is the path location and filename
of the configuration file, and password is the password for the user ID specified.
If only configupload is entered, the system will prompt you for each
parameter, as follows:
Example:
switch:admin> configupload
Server Name or IP Address [host]: 123.45.678.901
User Name [user]: kelev
File Name [config.txt]: switch1
Protocol (RSHD or FTP) [rshd]: ftp
Password:
upload complete