SAN switch 2/32 version 4.0.2b release notes

Prerequisites for Upgrading or Restoring Firmware
11SAN switch 2/32 Version 4.0.2b Release Notes
Note: SAN Switch 2/32 products require firmware Version 4.0.2b or higher.
Version 4.0.2b firmware and future upgrades are available on the HP website at:
http://h18006.www1.hp.com/products/storageworks/fcsanswitch232/index.html
Prerequisites for Upgrading or Restoring Firmware
Read this section before upgrading/restoring switch firmware.
Verify that a Windows NT or 2000 FTP Server is Installed
An FTP server must be installed and running when performing the telnet
command configUpload on a Windows NT or 2000 system. If you do not
have a Microsoft Windows NT or 2000 FTP service previously installed on your
system, you need to install it.
Use the following steps to install and configure a Windows NT or 2000 FTP
server.
1. Create a folder for the switch firmware and configuration files.
2. Install the Windows NT or 2000 FTP server on your system from your
Windows installation CD.
Note: If you only use the FTP server for the firmware and configuration loads, you can
specify the folder created in step 1 as the FTP Publish Directory.
3. Open the Internet Service Manager Tool.
4. Issue the configUpload command. Save the configuration.