SAN switch 2/32 version 4.0.2b release notes

Fabric OS Commands
22 SAN switch 2/32 Version 4.0.2b Release Notes
Note: It is recommended that you only use these commands from the serial console
port.
Example 1:
To advertise all modes of operation, follow this scenario for the ifModeSet
command:
Are you sure you really want to do this? (yes, y, no, n): [no] y
Proceed with caution.
Auto-negotiate (yes, y, no, n): [no] y
Advertise 100 Mbps / Full Duplex (yes, y, no, n): [yes] y
Advertise 100 Mbps / Half Duplex (yes, y, no, n): [yes] y
Advertise 10 Mbps / Full Duplex (yes, y, no, n): [yes] y
Advertise 10 Mbps / Half Duplex (yes, y, no, n): [yes] y
Committing configuration...done.
cp0:admin>
cp0:admin> ifModeSet eth0
Example 2:
To force 10 Mbps Half Duplex, follow this scenario for the ifModeSet
command:
cp0:admin> ifModeSet eth0
Are you sure you really want to do this? (yes, y, no, n): [no] y
Proceed with caution.
Auto-negotiate (yes, y, no, n): [no] n
Force 100 Mbps / Full Duplex (yes, y, no, n): [no]
Force 100 Mbps / Half Duplex (yes, y, no, n): [no]
Force 10 Mbps / Full Duplex (yes, y, no, n): [no]
Force 10 Mbps / Half Duplex (yes, y, no, n): [no] y
Committing configuration...done.
cp0:admin>