SAN switch 2/32 version 4.0.2b release notes

Fabric OS Commands

30 SAN switch 2/32 Version 4.0.2b Release Notes

Operands

This command has the following operands:

■ slot-Specify the slot number in a Core Switch. The slot number must be

followed by a slash ( / ) and the port number. The Core Switch has a total of

ten slots counted from 1 to 10. Slot number 5 and 6 are Control Processor

cards, and slot 1 - 4 and 7 - 10 are switch cards. On each switch card, there are

sixteen ports counted from the bottom 0 to 15. A particular port must be

represented by both slot number (1 - 4 or 7 - 10) and port number (0 - 15).

■ port-Specify a port number (0 - 15).

■ mode-Specify a value of 1 to delay the FLOGI Accept for this port until route

setup is complete. Specify a value of 0 to de-configure the delay of the FLOGI

Accept for this port.

Example

To configure switch port 3 as a “delayed FLOGI” port:

switch:admin> portcfgdelayflogi 1/3, 1

done.