SAN switch universal rack mount kit installation addendum

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit
5
Addendum Pg
HP StorageWorks SAN Switch 2/8|16|32 Installation Guide
Note: This kit contains both left rails and right rails. The rails are marked with Right
and Left to distinguish the rails from each other.
4. Assemble the outer rails by completing the following steps:
a. Attach the left outer rail and the right outer rails to the rear mounting
brackets using (2) 1/4-20 hex nuts with captive star lock washers attached
loosely as shown in Figure 4. Don’t tighten them. The nuts will be
tightened later in step 8.
Figure 4: Installing the outer rails (HP 9000 Series or comparable EIA rack)