Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 85
53-1000437-01
EM-1058
11
EM-1058
Message <timestamp>, [EM-1058], <sequence-number>,, WARNING, <system-name>, Switch gets
reset:
<Fault reason>
Probable Cause The switch is automatically reset due to known resetable transient errors, such as an
application-specific integrated circuit.(ASIC) parity. error.
Recommended
Action
No action is required if the switch does not reach the reset threshold for the switch/blade. If the
reset threshold is reached on the switch/blade, the switch/blade will be faulted and should be
replaced.
Severity WARNING
EM-1059
Message <timestamp>, [EM-1059], <sequence-number>, FFDC, CRITICAL, <system-name>,
Incompatible unit in
<FRU Id> faulted.
Probable Cause Indicates that a field-replaceable unit (FRU) inserted in the specified slot is not compatible with the
switch software. The blade will not be used.
Recommended
Action
Replace the blade. Make sure the replacement is compatible with your switch type.
Severity CRITICAL
EM-1060
Message <timestamp>, [EM-1060], <sequence-number>,, WARNING, <system-name>, Stopping
synchronization of the system due to blade incompatibility with software version
on standby CP.
Probable Cause A blade in the system is not supported by the release on the standby control processor (CP).
Recommended
Action
Please remove all blades of this type or upgrade your standby CP. Once an appropriate action is
taken, this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the
system will remain out of synchronization.
Severity WARNING
EM-1061
Message <timestamp>, [EM-1061], <sequence-number>,, WARNING, <system-name>,
Synchronization halted. Remove all blades of type
<Blade Type Id> or upgrade
your standby CP, then reboot or run haSyncStart.
Probable Cause A blade in the system is not supported by the release on the standby control processor (CP).