Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 113
53-1000437-01
Chapter
18
FCPD System Messages
FCPD-1001
Message <timestamp>, [FCPD-1001], <sequence-number>,, WARNING, <system-name>, Probing
failed on
<error string>.
Probable Cause Indicates that a fibre channel protocol (FCP) switch probed devices on a loop port, and the probing
failed on the either the L_Port, AL_PA address, or the F_Port. For the AL_PA, the valid range is 00
through FF. The error string can be either:
• L_Port port_number ALPA alpa_number
• F_Port port_number
Recommended
Action
This can happen when the firmware on the device controller on the specified port has a defect.
Check with the device vendor for a firmware upgrade containing a defect fix.
Severity WARNING
FCPD-1002
Message <timestamp>, [FCPD-1002], <sequence-number>,, WARNING, <system-name>, port <port
number>, bad R_CTL for fcp probing: 0x<R_CTL value>
Probable Cause Indicates that the response frame received on the specified port for a inquiry request contains an
invalid value in the routing control field.
Recommended
Action
This can happen only if the firmware on the device controller on the specified port has a defect.
Check with the device vendor for a firmware upgrade containing a defect fix.
Severity WARNING
FCPD-1003
Message <timestamp>, [FCPD-1003], <sequence-number>,, INFO, <system-name>, Probing failed
on
<error string> which is possibly a private device which is not supported in
this port type
Probable Cause Private devices will not respond to the switch port login (PLOGI) during probing.
Recommended
Action
The Brocade 4100, 4900, 5000, 7500, and AP 7600 do not support private loop devices. Refer to
the switch vendor for a list of other port types that support private devices for inclusion into the
fabric.
Severity INFO