Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 151

53-1000437-01

FSS-1006

Message <timestamp>, [FSS-1006], <sequence-number>,, WARNING, <system-name>, No FSS

message available

Probable Cause Indicates that data is not available on the Fabric OS state synchronization (FSS) device.

Recommended

Action

If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the

supportSave command and contact your switch service provider.

Severity WARNING

FSS-1007

Message <timestamp>, [FSS-1007], <sequence-number>,, CRITICAL, <system-name>,

<component name>: Faulty Ethernet connection.

Probable Cause Indicates that the Ethernet connection between the active control processor (CP) and standby CP is

not healthy. The error occurs when the standby CP does not respond to a request from the active

CP within 5 seconds. This usually indicates a problem with the internal Ethernet connection and a

disruption of the synchronization process.

Recommended

Action

Check the Ethernet connection between active CP and standby CP (interface eth1) by issuing net

commands such as ifconfig eth1 (as root) or run supportShow/supportSave to validate the network

configuration; then try to restore the synchronization by issuing the haSyncStart command. If the

problem persists, contact your switch service provider.

Severity CRITICAL