Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 287
53-1000437-01
Chapter
45
MFIC System Messages
MFIC-1001
Message <timestamp>, [MFIC-1001], <sequence-number>,, ERROR, <system-name>, failure at
sysmod_scn registry rc=
<failure reason>
Probable Cause Indicates that the system is temporarily out of resources.
Recommended
Action
No action is required; this message is often transitory.
If the message persists, run a switch reboot or an haFailover (if applicable).
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
MFIC-1002
Message <timestamp>, [MFIC-1002], <sequence-number>,, INFO, <system-name>, Chassis FRU
header not programmed for switch NID, using defaults (applies only to FICON
environments).
Probable Cause Indicates that custom switch node descriptor (NID) fields have not been programmed in nonvolatile
storage. The default values are used. The Switch NID is used only in the following SB ELS frames:
Request Node Identification Data (RNID) and Registered Link Incident Record (RLIR).
The use of SB-3 link incident registration and reporting is typically limited to FICON environments.
Recommended
Action
No action is required if SB-3 link incident registration and reporting is not used by the host or if
default values are desired for the switch node descriptor fields.
Severity INFO