Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 301
53-1000437-01
Chapter
50
NS System Messages
NS-1001
Message <timestamp>, [NS-1001], <sequence-number>,, WARNING, <system-name>, The response
for request 0x<CT command code> from remote switch 0x<Domain Id> is larger than
the max frame size the remote switch can support!
Probable Cause Indicates that the response payload exceeds the maximum frame size that the remote switch can
handle.
Recommended
Action
Run the firmwareDownload command to upgrade the remote switch with firmware v4.3 or higher,
or v3.2 or higher, as appropriate for the switch type, so that it can support GMI to handle frame
fragmentation and reassembly.
You can also reduce the number of devices connected to the local switch.
Severity WARNING
NS-1002
Message <timestamp>, [NS-1002], <sequence-number>,, WARNING, <system-name>, Remote switch
0x<Domain Id> has firmware revision lower than 2.2: <Firmware Revision 1st
character><Firmware Revision 2nd character><Firmware Revision 3rd
character><Firmware Revision 4th character> which is not supported!
Probable Cause Indicates that the local switch cannot interact with the remote switch due to incompatible or
obsolete firmware.
Recommended
Action
Run the firmwareDownload command to upgrade the remote switch to the latest level of firmware.
Severity WARNING
NS-1003
Message <timestamp>, [NS-1003], <sequence-number>,, INFO, <system-name>, Number of local
devices <Current local device count>, exceeds the standby can support <Local
device count that standby can support>, can't send update.
Probable Cause Indicates that the name server on the standby CP has lower supported capability than the active
CP due to different firmware versions running on the active and standby CPs. This means that the
active and standby CPs are out of sync. Any execution of the haFailover or firmwareDownload
commands will be disruptive.