Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

344 Fabric OS Message Reference
53-1000437-01
SEC-1043
63
SEC-1043
Message <timestamp>, [SEC-1043], <sequence-number>,, ERROR, <system-name>, Invalid port
range <Minimum> - <Maximum>.
Probable Cause Indicates that the specified port is not within the minimum and maximum range.
Recommended
Action
Use valid syntax when entering port ranges.
Severity ERROR
SEC-1044
Message <timestamp>, [SEC-1044], <sequence-number>,, ERROR, <system-name>, Duplicate
member <member ID> in (<List>).
Probable Cause Indicates that the specified member is a duplicate in the input list. The list can be a policy list or a
switch member list.
Recommended
Action
Do not specify any duplicates.
Severity ERROR
SEC-1045
Message <timestamp>, [SEC-1045], <sequence-number>,, ERROR, <system-name>, Too many port
members.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR