Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 403
53-1000437-01
SULB-1009
66
“firmwareCommit has started on the local CP. Please use firmwareDownloadStatus and
firmwareShow to see the firmware status.”
0x87
“firmwareCommit has started on the remote CP. Please use firmwareDownloadStatus and
firmwareShow to see the firmware status.”
0x88
“Please use firmwareDownloadStatus and firmwareShow to see the firmware status.” 0x89
“firmwareDownload command has completed successfully.” 0x8a
"The original firmware has been restored successfully." 0x8b
"Remote CP is restoring its secondary partition." 0x8c
"Local CP is restoring its secondary partition." 0x8d
"Remote CP is restoring its secondary partition." 0x8e
“firmwareDownload has started.” 0x8f
“firmwareCommit has started.” 0x90
“firmwareDownload has completed successfully.” 0x91
“firmwareCommit has completed successfully.” 0x92
“firmwareCommit has started to restore the secondary partition.” 0x93
“firmwareCommit failed.” 0x94
"The secondary partition has been restored successfully." 0x95
"Firmware is being downloaded to the blade. This step may take up to 10 minutes." 0xa0
“firmwareDownload timed out.” 0xa1
“Reboot occurred during firmwareDownload. firmwareCommit will be started to recover the
blade.”
0xa2
“Blade rebooted during firmwareCommit. The operation will be restarted.” 0xa3
"Firmware has been downloaded successfully. Blade is rebooting with the new firmware." 0xa4
"Blade has rebooted successfully." 0xa5
“New firmware failed to boot up. Please retry firmwareDownload.” 0xa6
“firmwareCommit has started on the blade. This may take up to 10 minutes.” 0xa7
“firmwareRestore is entered. System will reboot and a firmwareCommit operation will start
upon boot up.”
0xa8
"Switch is relocating the AP image." 0xa9
"The AP image is relocated successfully." 0xaa
"Switch reboots during relocating the AP image. The operation will be restarted." 0xab
“Blade failed to reboot with the original image. firmwareRestore command failed.” 0xac
TABLE 6 Status Messages and Status Codes
Status Message Status Code