Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 445
53-1000437-01
ZONE-1006
77
ZONE-1006
Message <timestamp>, [ZONE-1006], <sequence-number>,, WARNING, <system-name>, WARNING -
WWN(<WWN number>) in HARD PORT zone <zone_name>.
Probable Cause Indicates that one or more devices are zoned as world-wide name (WWN) devices and also zoned
as <domain, portarea> devices. The device(s) are used to specify zone members over separate
zones.
Recommended
Action
If hardware zoning enforcement is preferred, edit the zoning database to have the device zoned
using only one specification type, either WWN or <domain, portarea>.
Severity WARNING
ZONE-1007
Message <timestamp>, [ZONE-1007], <sequence-number>,, INFO, <system-name>,
Ioctl(<function>) in (<error message>) at port (<port number>) returns code
(<error string>) and reason string (<reason string>).
Probable Cause Indicates that frame filter logic reported a failure during one of the IOCTL calls. The IOCTL call from
which the failure is reported is listed as part of the error message. This is usually a programming
error when adding content-addressable memory (CAM) entries before the filter setup.
Recommended
Action
There are two ways to avoid this problem.
• Avoid having too many hosts zoned with a set of target devices at a single port.
• Avoid having too many zones directed at a single port group on the switch.
Severity INFO
ZONE-1008
Message <timestamp>, [ZONE-1008], <sequence-number>,, WARNING, <system-name>, WARNING -
port
<port number> Out of CAM entries.
Probable Cause Indicates that the total number of entries of S_ID CAM is above the limit while creating or adding a
zone group. The maximum number of content-addressable memory (CAM) entries allowed depends
on the application-specific integrated circuit (ASIC).
Recommended
Action
If hardware zoning enforcement is preferred, edit the zoning database to have zoned PIDs for that
port.
Severity WARNING