HP StorageWorks Fabric OS 5.3.1b release notes (5697-7644, August 2008)

Closed defect summary
Solution
When FRU in a 4/256 Director is inserted/removed a
fruHistoryTrap should be generated, but is not.
Fixed in Fabric O
S 5.3.0c. Note
that fruStatus
ChangeTrap
will not be gen
erated with FRU
insert/remove.
After upgrading switches to FOS 5.3.0, the Web Tools GUI bar
showing the "Initializing Switch Details" will get stuck at 93% if
the client’s regional and language settings are set to some non-US
languages such as Dutch, Russian, and Greek. English, French,
German, Italian, Spanish, Portuguese, Simplified Chinese, Traditional
Chinese, Japanese and Korean work fine.
Fixed in Fabric OS 5.3.0c.
A PLOGI received by 400 MP Router or FR4-18i prior to address
translation table being programmed may not get the correct doma in
name offset while operating in the open fabric mode, leading to
inability to boot over FCR connection for host that doesn’t retry PLOGI.
Fixed in Fabric OS 5.3.0c.
Web Tools
shows Ethernet speed at 0, even though it’s operating at
correct s
peed, due to underlying MAPS returning speed type rather
than pro
per speed.
Fixed in F
abric OS 5.3.0c.
Fabric OS 5.3.0d fixes
Table 7 lists defects closed in the Fabric OS 5.3.0d firmware release.
Table 7 Fabric OS 5.3.0d closed defects
Closed defec t summary
Solution
During POST & system verification tests, customer may see false
failures from stress tests only intended for engineering design
verification.
Removed "minicycle" for all
platformsaswellascertaintestsfor
multi-protocol router blade, & iSCSI
blade, with 5.3.0d.
When port t ype can’t be determined on 4/256 director during
filter install for any por ts greater than 256 (for example, installing
Performance Monitor on an offline port), filter could be programmed
incorrectly. If FC4-48 blade port greater than 256 is then enabled
as ISL, all frames will be dropped. Can also happen at corner event
timing sequence during port initialization, resulting in host not seeing
the target.
Fixed in Fabric OS 5.3.0d.
Swit
ch panic can occur due to HBA not shutting off light and sending
invalid primitives during boot, causing port "LOS S of SYNC" and
generating too m any interrupts.
Firmware changed to fault the port to
avoid too many interrupts generated
to C
PU in a short period of time with
5.3
.0d.
CertainWebToolsissuesexist(i.e. doesnotdisplayfabricevent
information with "https" access, & is unable to open Web Tools
GUI from laptop).
Fixed in Fabric OS 5.3.0d.
Cold boot of a heavi ly loaded chassis on the Brocade 4Gb
SAN Switch for HP c -Class BladeSystem during POST causes an
unexpected interrupt whereby POST fails and the switch faults.
Fabric OS 5.3.0d changed to delay
processing interrupts during POST.
24