HP StorageWorks Fabric OS 5.3.0c Release Notes (AA-RWEYG-TE, November 2007)

Vulnerabilities reported about open SSL VU#386964 & VU#547300.
For VU#547300:OpenSSL SSL_get_shared_ciphers() vulnerable to
buffer overflow. For VU#386964:OpenSSL SSLv2 client code fails to
properly check for NULL.
Fixed per Fabric OS 5.3.0
Denial-of-Service condition affecting X.509 certificates verification
(NISCC #7 29618) due to SSL vulnerability in OpenSSL. FOS 5.3.0
includes new version of OpenSSL that resolves this.
Fixed per Fabric OS 5.3.0
Incorrect time in Web Tools Switch Health report. Fixed per Fabric OS 5.3.0
IncorrectF_PortbehaviorwhenRXsideofthecableisdisconnected,
while the TX side is still inserted.
Fixed per Fabric OS 5.3.0
Installatio
nofPKIcertificate is delayed on any switch on which
installati
on is attempted due to timing of the startup function.
Fixed per Fabric OS 5.3.0
The last character of config uploa ded Ban ner (via “bannerset” CLI
command) will disappear when p erforming a configupload
followed by configdownload.
Fixed per Fabric OS 5.3.0
When connected to i10k Director in open mode, an RSCN received
from the i10k was not immediately for warded.
Fixed per Fabric OS 5.3.0
When upgrading 4/256 to Fabric OS 5.2.0b from 5.2.0a, both ISL
trunk connections to an edge switch connected to FC4-16IP were lost.
Found in test lab and due to “lab mode” setting, not accessible to
customers.
Fixed per Fabric OS 5.3.0
Counter Address_err counting inappropriate data. Fixed per Fabric OS 5.3.0
When assigning IP address to a G E port with no cable connection,
the FC 4-16IP Blade incorrectly reports back to iSCSI initiator that
port is valid.
Fixed per Fabric OS 5.3.0
The 4/8 and 4/16 SAN Switches would d isplay “Fan x is not faulty”
messages on boot up after upgrade to Fabric OS 5.2.0x, even
though
fans were ok.
Fixed per Fabric OS 5.3.0
Disconnecting R x end of cable on an L_port and leaving the Tx end
unchanged results in unexpected behavior.
Fixed per Fabric OS 5.3.0
Access Gateway should handle an IPv6 address in a GMAL payload
IP address in “ag – show” truncated to 16 characters (size of IPv4
address) depending on size of IP address string for edge switch to
which N_P ort attached.
Fixed per Fabric OS 5.3.0
Switchdisable and switchenable on s witch that directly
connects to storage will cause the storage to see GLIEN reject error
message.
Fixed per Fabric OS 5.3.0
F_Port count is incorrect in agshow on the 4/32 SAN switch.
Fixed per Fabric OS 5.3.0
In CLI, iscsicfg –show/delete ddset –n xxx complains “requested
object doesn’t exist” even though it does exist, due to DD/DDSETs
received from Mic rosoft iSNS server being in uppercase .
Fixed per Fabric OS 5.3.0
HP StorageWorks Fabric OS 5.3.0c release notes
23