HP StorageWorks Fabric OS 5.X Advanced Web Tools Administrator Guide (AA-RVHYB-TE, September 2005)

100 Administering zoning
Using zoning wizards
The Zone Admin module contains the following wizards to help you perform the zoning tasks:
• Add Un-zoned Devices
• Remove Offline Devices
• Replace Offline Devices
• Define Device Alias
The wizards are accessed through the Tools menu in the Zone Admin module. The following sections
describe the zoning tasks and the procedure for accessing the wizards for each task. The wizards are
self-explanatory, so the specific steps are not documented here.
NOTE: The left side of each wizard window lists the steps you need to take to complete the task. The
current step is in blue, as shown in Figure 32. Some of the wizards allow you to loop and repeat the task
multiple times; as a result, each step is listed in this panel, so that you not only see the steps that you still
need to perform, but also the steps that you have already performed. The step numbers may not match the
overall numbering in this panel.
Figure 32 Add Un-zoned Devices wizard
Adding unzoned online devices to a zone or alias
When zoning is enabled, devices that are not included in a zone configuration are inaccessible to other
devices in the fabric. Use the following procedure to identify online devices that are not zoned in any
zone configuration and add them to a zone or alias.
1. Launch the Zone Admin module as described on page 83.
2. Select Tools > Add Un-zoned Devices.
The Add Un-zoned Devices wizard starts.
3. Follow the steps outlined in the wizard.
The wizard displays unzoned devices and prompts you to select them and add them to an alias or a
zone.