Fabric Watch Administrator's Guide v6.4.0 (53-1001770-01, June 2010)

106 Fabric Watch Administrator’s Guide
53-1001770-01
Port threshold configuration using the fwConfigure command
A
Changing the threshold boundary level
NOTE
The allowed advanced settings are displayed on a per-class basis. Although port fencing is displayed
for other areas, such as RX Performance, for which port fencing is not supported, you will not be able
to set or apply the changes on such areas.
1. Enter 4 at the Select choice => prompt.
The system generates output, which varies based on the class and area you select. In the
example shown here, the output is based on the E_Port class and RXPerformance area.
Index ThresholdName BehaviorType BehaviorInt
216 eportRXPerf216 Triggered 1
217 eportRXPerf217 Triggered 1
218 eportRXPerf218 Triggered 1
219 eportRXPerf219 Triggered 1
220 eportRXPerf220 Triggered 1
221 eportRXPerf221 Triggered 1
222 eportRXPerf222 Triggered 1
223 eportRXPerf223 Triggered 1
Threshold boundary level is setat : Default
DefaultCustom
Unit Percentage(%) Percentage(%)
Time base minuteminute
Low 0 0
High 100 100
BufSize 0 0
Threshold alarmlevel is set at: Default
Errlog-1, SnmpTrap-2, PortLogLock-4
RapiTrap-8, EmailAlert-16, PortFencing-32
Valid alarm matrix is 63
DefaultCustom
Changed 0 0
Below 0 0
Above 0 0
InBetween 0 0
1 : change behavior type 11 : change threshold alarm level
2 : change behavior interval 12 : change changed alarm
3 : change threshold boundary level 13 : change belowalarm
4 : change custom unit 14 : change abovealarm
5 : change custom timebase 15 : change inBetween alarm
6 : change custom low 16 : apply threshold alarm changes
7 : change custom high 17 : cancel threshold alarm changes
8 : change custom buffer 18 : return to previous page
9 : apply threshold boundary changes
10 : cancel threshold boundary changes
Select choice => : (1..18) [18]7