HP StorageWorks Fabric OS 5.3.x administrator guide (5697-0244, November 2009)

Fabric OS 5.3.0 administrator guide 381
3. Enter the cfgSave command to save the change to the defined configuration.
NOTE: For Fabric OS versions earlier than v4.4.0, when using the aliRemove command, the order in
which the members appear in the list is critical. For more information on this command, refer to the Fabric
OS Command Reference Manual.
To delete an alias
1. Connect to the switch and log in as admin.
2. Enter the aliDelete command.
3. Enter the cfgSave command to save the change to the defined configuration.
To view an alias in the defined configuration
1. Connect to the switch and log in as admin.
2. Enter the aliShow command.
The following example shows all zone aliases beginning with “arr”.
If no parameters are specified, the entire zone database (both the defined and effective configuration) is
displayed.
Creating and maintaining zones
Before executing cfgDisable,cfgEnable, or cfgSave, execute the rcsDisabled command to
check whether or not your fabric has Reliable Commit Service (RCS) enabled (rcsDisabled=0). If RCS is
disabled (rcsDisabled=1), check for older switches in the fabric. After the older switches are upgraded,
RCS is enabled by default.
RCS is available on all switch versions 4.1 and later. RCS guarantees that either all or none of the switches
receive the new zone configuration. It is recommended that you use RCS to secure a reliable propagation
of the latest zone configuration. If you use non-RCS mode, you must log in to every switch to monitor the
status of the zone configuration.
To create a zone
1. Connect to the switch and log in as admin.
2. Enter the zoneCreate command.
switch:admin> aliremove “array1”, “1,2”
switch:admin> aliremove “array2”, “21:00:00:20:37:0c:72:51”
switch:admin> aliremove “loop1”, “4,6”
switch:admin> cfgsave
You are about to save the Defined Zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined Zoning configuration only? (yes, y, no, n): [no] y
switch:admin> alidelete “array1”
switch:admin> cfgsave
You are about to save the Defined Zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined Zoning configuration only? (yes, y, no, n): [no] y
switch:admin> alishow “arr*”
alias: array1 21:00:00:20:37:0c:76:8c
alias: array2 21:00:00:20:37:0c:66:23