HP StorageWorks Fabric OS V3.1.3A Release Notes (AA-RUQYC-TE, September 2004)

New Diagnostic and System Error Messages
55Fabric OS 3.1.3a Release Notes
Message
Critical DIAG-NOSEGMENT, 1
Probable Cause
Port failed to go into loopback mode. This message usually indicates improper
cable connections. This message is generated by the spinsilk command, if
problems are found.
Recommended Action
Verify cable connections. Reseat the SFPs and cables and then reexecute the test.
Check for a faulty cable or deteriorated SFP. Replace the cable or SFP if
necessary.
Severity
Critical
Message
Critical DIAG-PORTABSENT, 1
Probable Cause
Port is not present. This can be caused by a faulty cable or deteriorated SFP. It can
also indicate deeper problems in the motherboard or ASIC. This message is
generated by the portloopbacktest or spinsilk commands.
Recommended Action
Check for a faulty cable or deteriorated SFP. Replace the cable or SFP.
If the problem persists:
For the SAN Switch 2/16, replace the motherboard FRU.
For the SAN Switch 2/8, you must replace the entire switch.
DIAG-NOSEGMENT
DIAG-PORTABSENT