StoreEver LTO SAS full height tape drives user guide

5 Verify installation
Once you have installed the drive hardware, check that drivers have been installed correctly and
you have the correct version of backup software, and verify that the tape drive is functioning
properly before you store your valuable data.
1. Switch on the drive and the server.
2. The tape drive will run its hardware self-test, which takes about 5 seconds. If self-test passes,
the green Ready LED flashes and then shows steady green. If the test fails, the Drive Error and
Tape Error LEDs flash, while the Ready and Clean LEDs are off. This continues until the drive
is reset. See Understanding LED sequences (page 49) for more information about front panel
lights.
If you installed drivers before connecting the tape drive (Windows only)
The tape drive should be detected automatically and the correct drivers used. (See Install
drivers (page 12).) If the Windows Found New Hardware wizard runs, cancel it - you
can use Device Manager to check that the driver is installed.
Installing drivers after connecting the tape drive (Windows only)
If you have not already installed drivers, the Windows Found New Hardware wizard
will run when you power on the server and tape drive. Either follow the on-screen
instructions to search for the required driver on the HP Tape CD-ROM or cancel the wizard
and run the install package from the CD-ROM.
Installing drivers (other operating systems)
Drivers are included with the operating system and should be loaded automatically. To
upgrade drivers we recommend that you patch to the latest version of the operating
system.
NOTE: Certain backup applications require you to use their own Tape driver instead of the
HP Tape driver.
3. Verify that the tape drive installation was successful.
HP LTO Library & Tape Tools (L&TT) is the recommended diagnostic and support tool for your
HP tape drive. Use it to verify installation and confirm that your tape drive is functioning
correctly before you use it for backup. It is available free at http://www.hp.com/support/
tapetools.
4. For all operating systems ensure that you have downloaded any upgrades necessary for your
backup application. Check http://www.hp.com/storage/spock for software compatibility
and install any recommended upgrades.
5. Carry out a backup and restore test to check that the drive can write data to tape. Use a blank
cartridge.
Windows Backup or UNIX native backup applications can be used to check basic tape drive
operation, but they will not support all the advanced features of your tape drive. We
recommend that you upgrade your software application before running this test.
32 Verify installation