StoreEver LTO SAS full height tape drives user guide

Figure 2 SAS with power cable supplied with LTO–6 Ultrium 6650 and LTO-5 Ultrium 3280 internal
tape drives
2. Unused second branch on supplied cable1. Mini-SAS connector to server (remove cover)
4. SAS connector to tape drive3. Mini-SAS connector on second branch (unused, do not
remove cover)
5. Power cable and connector to server's power supply
Figure 3 SAS without power cable supplied with LTO–4 Ultrium 1840 internal tape drives
2. Unused second branch on supplied cable1. Mini-SAS connector to server (remove cover)
4. SAS connector to tape drive3. Mini-SAS connector on second branch (unused, do not
remove cover)
CAUTION: With all tape drives prior to LTO–6 Ultrium 6650 and LTO-5 Ultrium 3280, never
use a cable where power is supplied through the SAS connector because this may damage the
drive. Always use a spare power cord from the server's internal power supply to the conventional
power connector on the drive itself.
See Connect SAS and power cables (page 18) for detailed instructions on connecting the SAS
cable.
External drives
External tape drives must be connected to an external port. The cable supplied with the tape drive
is suitable for connecting to an external Mini-SAS (SFF-8088) port on a dedicated HBA
(recommended) or the host SAS controller. If your server has an external Infiniband (SFF-8470)
connector, a suitable cable is available, but must be purchased separately, see http://www.hp.com/
storage/spock.
8 Before you start