HP StorageWorks 6000-series Virtual Library System User Guide (AH809-96049, September 2010)

CAUTION:
Electrostatic discharge can damage electronic components. Properly ground yourself before beginning
any installation procedure.
1. Power off the node. See Powering Off the System.
2. Extend the node from the rack. See Extending the Node from the Rack.
3. Lift up on the hood latch handle which slides the panel toward the rear of the unit.
4. Lift up the panel to remove it.
Removing the VLS6600 Node Access Panel
WARNING!
Pressing the Power on/Standby button sets the node to the standby position, which removes power
from most areas of the node. However, portions of the power supply and some internal circuitry
remain active until the AC power cord is removed.
WARNING!
To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool
before touching them.
CAUTION:
Do not operate the node for long periods without the access panel. Operating the node without the
access panel results in improper airflow and improper cooling that can lead to thermal damage.
CAUTION:
Electrostatic discharge can damage electronic components. Properly ground yourself before beginning
any installation procedure.
1. Power off the node. See Powering Off the System.
2. Extend the node from the rack. See Extending the VLS6600 Node from the Rack.
3. Use the T-15 Torx screwdriver attached to the rear of the node to loosen the security screw on
the hood latch.
4. Lift up on the hood latch handle and remove the access panel.
HP StorageWorks 6000–series Virtual Library System User Guide 263