HP StorageWorks 6000-series Virtual Library System User Guide (AH809-96049, September 2010)

Removing the VLS6800 Node Access Panel
WARNING!
Pressing the Power on/Standby button sets the node to the standby position, which removes power
from most areas of the node. However, portions of the power supply and some internal circuitry
remain active until the AC power cord is removed.
WARNING!
To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool
before touching.
CAUTION:
Do not operate the node for long periods without the access panel. Operating the node without the
access panel results in improper airflow and improper cooling that can lead to thermal damage.
CAUTION:
Electrostatic discharge can damage electronic components. Properly ground yourself before beginning
any installation procedure.
1. Power off the node. See Powering Off the System.
2. Extend the node from the rack. See Extending the VLS6800 Node from the Rack.
3. Unlock the access panel latch.
4. Lift up on the latch, and remove the access panel.
Figure 78 Removing the access panel
.
Component Replacement264