HP StorageWorks 6000-series Virtual Library System User Guide (AH809-96049, September 2010)

Installing the VLS6100, VLS6200, or VLS6500 Node Access Panel
1. Set the access panel on top of the node about a ¾ inch (0.2 inch for the VLS6200) from the
opening with the hood latch open.
2. Engage the anchoring pin with the corresponding hole in the latch.
3. Push down on the hood latch.
4. Slide the access panel into the closed position.
Installing the VLS6600 Node Access Panel
1. Set the access panel on top of the node about a 1/2 inch from the opening with the hood latch
open.
2. Push down on the hood latch.
3. Slide the access panel into the closed position.
4. Use the T-15 Torx screwdriver attached to the rear of the node to tighten the security screw on
the hood latch.
Installing the VLS6800 Node Access Panel
1. Place the access panel on top of the node with the latch open. Allow the panel to extend past
the rear of the node approximately 1.25 cm (0.5 inches).
2. Push down on the latch.
3. Slide the access panel into the closed position.
VLS6100 and VLS6500 Node Component Replacement
SATA Hard Drive
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are
populated with either a component or a blank.
NOTE:
SATA hard drive LED functionality and hot-plug capability are not currently supported.
1. Power off the node. See Powering Off the System.
2. Press the drive latch release button (1).
HP StorageWorks 6000–series Virtual Library System User Guide 265