HP StorageWorks 6000-series Virtual Library System User Guide (AH809-96049, September 2010)

NOTE:
DIMMs do not seat fully if turned the wrong way.
When replacing a DIMM, align the DIMM with the slot and insert the DIMM firmly, pressing down
until the DIMM snaps into place. When fully seated, the DIMM slot latches lock into place.
VLS6200 Node Component Replacement
SATA Hard Drive
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are
populated with either a component or a blank.
NOTE:
The node contains one of several possible hard drives. The replacement hard drive must be the same
capacity as the original hard drive; refer to the label on the front of the original hard drive for the
correct supported replacement capacity and part number.
1. Press the drive latch release button (1).
2. Pull the hard drive (3) out of the node by the latch handle (2).
Figure 87 Removing a Node Hard Drive
.
To replace the component, pull out the latch handle (2) out as far as it can go and slide the drive into
the bay until the latch mechanism engages the chassis. Then, firmly push in the latch handle to lock
the drive in the drive bay.
HP StorageWorks 6000–series Virtual Library System User Guide 271